Which is better to choose front brake pads for Lada Kalina

The Lada Kalina, regardless of generation, uses front disc and rear drum brakes.

The process of stopping the machine is accompanied by wear of the pads, so they must be periodically replaced.

It’s easy to do it yourself, and if difficulties arise, it is recommended to watch a thematic video.

Article number and estimated cost of original front pads

The first generation Lada Kalina was equipped with brake disc pads with article numbers 21100-3501080-01 and 21100-3501080-00. Their price ranges from 460 to 500 rubles. The service life of the pads depends on the driving style and for most car owners it is 35-45 thousand km.

New brake pads have been developed for Lada Kalina 2. Their article number is 11180-3501080-00, and the price is 260-290 rubles. Consumables are not interchangeable with products for Kalina 1. Their service life can reach 60-70 thousand km, but usually replacement is required at 40 thousand km. The same pads are installed on the Lada Kalina Cross.

Brake pads 11180-3501080-00

There are pads for Lada Kalina Sport. They are installed as tuning on standard cars, but this requires replacing the caliper. Consumables have improved performance characteristics.

Factory pads produced by AvtoVAZ

As for the service life, I have no complaints here at all, in this they completely suit me. Judge for yourself, they spent 30 thousand and could have served just as long. But there are huge complaints about the quality of braking; to put it mildly, there was none at all. I remember there were several cases when it was difficult to avoid a collision in city traffic. While I pressed the brake pedal with all my might, the car continued to float without noticeable slowdown. It was after several such cases that I decided to change it, but as it turned out, I ended up with a fake.

Article number and price of recommended front brake pads for Kalina from third-party manufacturers

The brake pads installed from the factory have satisfactory quality and performance characteristics, so for replacement it is better to choose analogues from third-party manufacturers. The recommended non-original consumables listed below will ensure smooth and intense braking without any extraneous sounds.

Table - The best analogs of pads 21100-3501080-00 and 21100-3501080-01

Table - Good analogues 11180-3501080-00

Article number and approximate cost for rear original Kalina pads

Rear original drum pads for Lada Kalina of the first and second generation have article number 21080-3502090-01 in the case of the basic configuration. If the car is equipped with ABS, then the installed consumables come with catalog number 11180-3502090-10. The price of products ranges from 720 to 890 rubles. Replacement of pads is required every 70-90 thousand km.

see also

Brake pad wear

5 0 5k

How to check your car brakes

2 0 4k

Brake cleaner

4 2 22k

Uneven pad wear

30 1 22k

Brakes jerkily

73 0 84k

Lada Kalina cars of both generations have front disc brakes and rear drum brakes.
As original front brake pads for Kalina 1, the catalogs indicate 21100-3501080-00 and 21100-3501080-01, for Lada Kalina 2 the article number is 11180-3501080-00. The same catalog numbers are used for Lada Priora. Factory brake pads TIIR

Rear drum brake pads are specified as 21080-3502090-01 or 11180-3502090-10 (with ABS) for Kalina 1 and 2.

Many of these part numbers are invalid; instead, online parts stores offer other original part numbers or equivalents. This makes sense, since in the case of the Lada Kalina (and LADA in general), the original is often inferior in quality to its substitutes .

The most popular brake pad analogues are Ate, Brembo, TRW, TSN, Finwhale and Ferodo. The latter are divided into two types according to the color of the box - “red” and “green”. “Green” ones, with the prefix Target in the name, are positioned by the manufacturer as an improved replacement for factory pads , but they are not intended for heavy loads. Red, with the prefix Premier, are considered premium pads that can withstand extreme loads.

The best-selling disc brake pads for Lada Kalina are products from Ate, followed by TRW. Drum brake pads for Kalina are most often purchased from TSN due to its favorable price. They are slightly inferior in popularity to TRW and Ate pads.

According to the rating of brake pads for Lada Kalina on PartReview dated 04/02/20, owners prefer TIIR products. Manufacturers TRW, Trialli and Ferodo also stand out.

The brake pads indicated here are also suitable for other VAZ cars: 2110, 2114, Lada Granta and others, with R13 and R14 brake discs.

Front brake pads are replaced approximately twice as often as rear brake pads. The exact frequency of replacement is quite difficult to establish, but the front pads are changed at intervals of 30-50 thousand km, and the rear pads at intervals of 60-90 thousand. To more accurately determine when Lada Kalina brake pads need to be replaced, it is worth checking the thickness of the friction linings every 15,000 km. A thickness of about 2 mm is considered critical.

Article number and cost of good analogs of original rear brake pads for Lada Kalina

When stopping, the rear axle does not bear the main braking force. Therefore, a more important characteristic for drum pads is their quietness. Original consumables cannot boast of the absence of squeaks and squeaks. Because of this, car owners prefer analogues from third-party brands, the best of which are listed below.

Table - Recommended analogues 21080-3502090-01

Table - Recommended alternatives for 11180-3502090-10

Replacing front pads on Kalina

Instructions for replacing the front brake pads are given below.

• Jack up the car.
• Remove the front wheel.
• Turn the steering wheel to make it easier to replace the pads.
• Bend the locking plate.

• Insert a screwdriver and press in the brake piston. If this is not done at this stage, then later you will need to use a clamp.

• Unscrew the lower caliper bracket fastener.

• Open the caliper bracket.

• Remove old pads. If necessary, rearrange the anti-violin plates.

• Install the pads in their seats.

• Reassemble everything in the reverse order of removal.

• Check the operation of the brakes. A decrease in the intensity of stopping the car is associated with running in the pads

What to look for when choosing pads

Before replacing brake pads on Kalina, you need to understand the types of plates. These elements are:

• semi-metallic;
• low steel content;
• ceramic;
• polymer.

The semi-metallic brake pads on Kalina are based on steel fiber. Thanks to this, the part has a long service life and high technical characteristics. Metal elements are characterized by a good coefficient of friction.

The only drawback is rapid wear, especially if the part is cheap or made of low-quality material.

If Kalina brake pads contain a low percentage of steel fibers, then in terms of their quality characteristics they are durable and wear-resistant. The disadvantage of the part is the low production of the brake disc.

The ceramic elements contain inclusions of shavings. These are durable plates that can last a long time and provide a good coefficient of friction. However, their quality is still significantly worse than those described above.

Polymer brake discs for Kalina are made of high-strength materials. This type of plate was developed not so long ago, but has managed to gain popularity among many motorists. Polymer materials guarantee a long service life and are highly durable. A high-quality part is expensive, but it guarantees long and successful operation.

Before purchasing brake discs for Kalina, you need to figure out which type will be most suitable. It is recommended to make purchases in trusted stores. What material the part will be made from is decided by the buyer himself.

Step-by-step instructions for replacing rear pads

The algorithm for replacing rear drum pads is given below.

• Shift the gearbox to first speed.
• Remove the wheel by first jacking up the car.

• Unscrew the pins that secure the drum.
• Tap the back of the cover with a hammer using a wooden spacer. This will allow you to tear the drum out of place and remove it with loosening movements.

• Remove the cotter pin.

• Remove the lower spring that tightens the pads.

• Move the block to the side until the spacer bar leaves its seat.

• Remove the pads.

• Disconnect the handbrake lever and other parts. Replace everything with new consumables.

• Check the condition of the springs and, if necessary, replace them with new ones. To do this, you will need to purchase a special repair kit.
• Reassemble everything in the reverse order of disassembly.
• Check the brakes.

When to change

Pads are consumables and must be replaced as their lifespan wears out. For Kalina front pads it is usually 20-30 thousand km. However, this does not mean at all that during this period the pads do not need to be inspected to assess their condition.

In order to be sure that they will not let you down at the right time, it is recommended to have them diagnosed at least twice a year, when changing tires. Rear pads usually wear out less and last three times longer than the front ones.

For the Lada Kalina, the thickness of the friction lining for each of the pads (regardless of the rear or front) must be at least 1.5 mm. You can measure it using a caliper or a regular ruler. If you suddenly discover that the lining is thinner than this value, or has signs of mechanical damage (chips, cracks, tears), hurry to replace the pads.